How to pair and setup the remote on Titan 4WD

How to pair and setup the remote on Titan 4WD electric skateboard

 

 

Prepare--- both the board and the remote are at off option

1. Long press the remote switch button for around 5 second,get into the 4wd mode

2. One press the remote switch button get into pairing the ESC1 , long press the board's switch button (ESC on the back side) for around 5seconds, till the remote show ' remote paring ok ', that means the ESC1 finishes paring

3. One press the remote switch button get into pairing the ESC2 , long press the board's switch button (ESC on the front side) for around 5seconds, till the remote show ' remote paring ok ', that means the ESC2 finishes paring

4. Then the remote will get into the setup mode, you could set up the speed unit , motor type,wheel diameter,drive retio,motor pole pairs,brake level

Finished the paring and setup.

Note: The ESC1 and ESC2 pairing cannot be reversed, otherwise the forward direction will be reverse

Zurück zum Blog

Hinterlasse einen Kommentar

Bitte beachte, dass Kommentare vor der Veröffentlichung freigegeben werden müssen.