How to pair and setup the remote on Titan 4WD electric skateboard
Prepare--- both the board and the remote are at off option
1. Long press the remote switch button for around 5 second,get into the 4wd mode
2. One press the remote switch button get into pairing the ESC1 , long press the board's switch button (ESC on the back side) for around 5seconds, till the remote show ' remote paring ok ', that means the ESC1 finishes paring
3. One press the remote switch button get into pairing the ESC2 , long press the board's switch button (ESC on the front side) for around 5seconds, till the remote show ' remote paring ok ', that means the ESC2 finishes paring
4. Then the remote will get into the setup mode, you could set up the speed unit , motor type,wheel diameter,drive retio,motor pole pairs,brake level
Finished the paring and setup.
Note: The ESC1 and ESC2 pairing cannot be reversed, otherwise the forward direction will be reverse
